Likely practically nothing you can do relating to this, since it is often prompted because the hulls have gotten damp and the first primer and metal head have began to corrode, Despite the fact that there might not be some real proof of it.



This can be an more mature thread, you may not get a reaction, and will be reviving an old thread. Be sure to contemplate making a new thread.

Cheddite 209 primers are usually much less impressive than Federal 209A primers and have a decrease sensitivity. Consequently they may have to have a slightly more robust hammer strike to ignite the primer and will be more unlikely to ignite in chilly climate or in guns with weaker firing pins.

Insert to estimate Only display this person #9 · Apr 21, 2021 Nicely I shot the loads these days. I bought much less recoil I feel. The pictures felt smoother. I used to be in a position to comply with by way of easier. Unsure if that’s because the velocity is simply too large or too lower.

The one thing that matters is force and darn couple people will shell out the money to amass the equipment To accomplish this but if you do, that hugely (evidently) essential velocity is going to be received (and properly).

Then at some juncture this ceased, plus they were transitioned to CX2000. I believe the CX1000 remains available within the EU and UK, together with the CX2000.

Gordy, The challenge some individuals have may be the primer pocket can get starched out within the oversize of the foreign primer. I don't have challenges as foreign primers is all I are already employing on account of price.  

I labored with laboratories for years And that i saw lots of faults. All good laboratories have stringent QA/QC pointers which if not strictly adhered to, will routinely invalidate data. I would like to see Precision's certified standards and calibration data for openers.

I have been employing cheddite for years and have never experienced troubles with it, a lot of my reloads are with cheddite .  

have used winchester primers for years with no difficulties. just commenced with cheddites this week. they seemed good but now my firing pin is piercing the primer. loading sts gentle loads, in K80. now screwded again!  

I just hope I did not squander 300 hulls for this examination for an acquaintance. I have sufficient of cheddite's to very last me many years, the W209's had been only for a take a look at. I will not be acquiring any if/after they occur obtainable.

I'm sure a few of the crappy spaghetti guns develop many recoil and that can result in pierced primers but that is not simply with Cheddite primers which is with a lot of models.

Not so new member aged aka winchester 209 primers shortage before moving to KY was Ohio Wildfowler ( was a moderator on a pair forums)

You've asked the associates of this forum for suggest about safely swapping factors to get a load you want.